HB Industries CZ Scorpion EVO3 THETA FORWARD Trigger
Alternatives, gerades Abzugszüngel von HB Industries
Bringt den "Abzug" weiter vor, siehe Darstellung.
The Theta Forward trigger for the CZ Scorpion EVO 3 is a flat faced trigger with a +5mm forward position that provides increased leverage over the factory trigger. The increased leverage will reduce the trigger pull weight by about 12%*. When compared to a curved trigger, the flat surface profile on our Theta triggers provides a more tactile and consistent trigger pull regardless of where the operator places their finger. The increased repeatability in pull force and trigger movement makes every shot feel just like the last, allowing for quicker and more accurate follow up shots. The Theta triggers are precision machined from billet aluminum available in black or red. Made in the USA, this part counts towards 922R compliance. Trigger includes a new roll pin for seamless installation.
- Theta Forward Flat Faced Trigger
- Increased Leveraged, Reduced Pull Weight
- Available for both the Factory Sear and CZ Custom Trigger Pack
- Fits CZ Scorpion EVO3 Pistol and Carbine
- Made in USA, 922R compliant
- Drop In Replacement, Includes Roll Pin
- Machined Aluminum 6061-T6
- Available in Black or Red
*Please note: This 12% trigger pull force reduction comes at a cost. The +5mm forward face position provides a noticeable increase in leverage about the trigger mechanism pivot, especially with the factory 10lb+ trigger spring. However, placing the face of the trigger forward of the factory trigger does increase the length of pull (LOP) by +5mm, and does very slightly increase the travel of the trigger itself by about 1mm. These trade-offs will not impact most shooters, but should be known.
Gunsmith Installation Recommended for All Parts.